The sand making machine is installed on the concrete foundation or the steel structure foundation, and the foundation should be able to accept 4 times the weight of the whole machine. Depending on the location of the sand making airport, it can be installed in the factory or outdoor work. An hour, sand making should be installed. The machine is leveled so that the main shaft is perpendicular to the degree. Lifting equipment should be set above the sand making machine, and the weight of the lifting equipment should be considered according to the large component of the cracking machine. There should be a lifting space above the cracking machine, and a proper space should be left on the side of the cracking machine. To prepare for maintenance.

1: The crusher ratio of the sand making machine can reach more than 50, while the jaw crusher, shale crusher and wet material crusher are difficult to exceed 20.

2: Large processing capacity, high output-50-500t/h, compared with sand making equipment under the same power, the output is increased by 35%. And the performance is relatively stable.

3: Low consumption of wearing parts-----reasonable material impact speed design and less friction of wear-resistant parts, 30% lower than the operating cost of traditional equipment, directly reducing the cost of using the impact crusher and greatly improving the machine Profit margins.

4: The finished product has a good grain shape-it is a six-sided polygonal prism, and the composition is reasonable, especially for machine-made sand and stone shaping. It has been proved by many customers that the comprehensive effect of sand making and shaping is 30% higher than that of other equipment of the same power.

Compared with other crushers, the sand making machine has the advantages, and there are also some objective defects. Because the sand making machine uses the impact principle to crush materials, the vulnerable parts are unavoidable, such as: hammer, plate hammer, The impact board, etc., are also more severely worn in use. Although this defect is difficult to improve for a long period of time, it limits the scope of application of the sand making machine and can only stay at the level of crushing medium-hard materials. I believe. With the application of new wear-resistant materials, Henan has made great efforts to improve, and while extending the service life of the sand making machine to a large extent, it will no longer be a problem to control the production cost of the enterprise within a certain range.